51401497-100 Honeywell Power Supply Module

Honeywell 51401497-100 Concise English Technical Specification
Basic Information
Brand: Honeywell
Model: 51401497-100, FW25-92
Product Name: TDC300 LCN Rack Node Power Supply Module
Origin: United States
HS Code: 85044090
Dimension: 310mm × 128mm × 42mm
Net Weight: 1.45kg

Electrical & Environmental Parameters
Input power: 100–240V AC wide-range alternating current
Multi-channel DC output: +5V, ±12V regulated DC power for rack backplane
Full load power consumption: 180W maximum
Operating temperature range: -20°C ~ +60°C
Storage temperature: -40°C ~ +85°C
Humidity: 5%–95% non-condensing
Protection grade: IP20 for indoor control cabinet installation
Certifications: CE, UL, ATEX Zone 2
Core Product Characteristics
Standard single-slot rack plug-in design compatible with all TDC300 LCN chassis; built-in overvoltage, overcurrent, short-circuit and overheating automatic protection circuits; low output ripple voltage to avoid interference to sensitive control signals; supports hot-swap replacement without full system power outage; integrated heat sink for reliable heat dissipation under continuous heavy load; conformal coated circuit board to resist dust, moisture and industrial corrosive gas; front panel LED indicators for power status and fault alarm; redundant parallel deployment available to achieve uninterrupted power supply for critical process units.
Wiring Instruction
Insert the module into the dedicated slot of Honeywell TDC300 LCN rack to connect backplane power distribution bus. Connect mains AC power cable to the rear input terminal block with shielded power wires, single-point ground the cable shielding layer to cabinet ground bar. Separate high-power AC wiring and low-voltage signal wiring to eliminate electromagnetic noise crosstalk.